We use cookies to ensure that we give you the best experience on our website. If you continue, we'll assume that you are happy to receive all cookies on our website. Find out more.
OK

Facade refurbishment using the Pullex refurbishment products

Greyed and weathered wooden facades and wooden structures look as good as new in an instant....

Using the Pullex Renoviersystem from ADLER that has been tried and tested over many years, greyed and weathered shutters, balconies or canopies appear as good as new in an instant and without any cumbersome sanding. And all that in just a few steps.

HOW IT WORKS:

Select the desired colour shade that you wish to apply to the item after refurbishment. The ADLER colour fans or colour charts will make the job of selecting the glaze finish colour shade easy for you.

 

Now, you need to test the substrate before you can begin with the coating.

 

Professional tip: Use the nail test to see whether the substrate has the load-bearing capacity required for a new coat. The deeper the traces of scratches, the more rigorously should you brush the wood at the end.

 

You must always use a brass wire brush for brushing, and always brush along the wood fibres. Those who wish to dispense with cumbersome brushing by hand use a professional brushing machine, particularly for large surfaces.

 

You can get rid of sharp edges at the end using sandpaper of grain size 80. It is best to sand even heavily weathered and horizontal boards.  Next, thoroughly remove all dust and dirt from the wood.

 

Now you can apply Pullex Renovier-Grund with a brush.

 

Professional tip: Please take care to ensure that you get a nice and uniform coloration. The surface should be uniformly coloured, but not appear to be covered completely. You can easily avoid crusts by smearing board by board.

 

Highly absorbent wooden structures can be coated a second time "wet on wet" within a maximum of half an hour.

 

After the drying time specified, you can apply the first topcoat with Pullex Plus Lasur or Top-Lasur in the colour shade desired. Now, too, you should apply the coats board by board,  and draw the brush smear at the end once again from the beginning of the board to the end. This is how you can prevent the formation of crusts!

 

After allowing sufficient time for drying, you can apply the second topcoat using one of the Pullex glaze finishes.

 

View user film on facade refurbishment...

Zum ADLER Online-Shop: